We came across a great article and felt we needed to share. Original article can be found on: InVia Fertility Specialists Blog

Disclaimer:  Reprogene currently has no affiliation with the clinic.  We are simply sharing their article.

During in vitro fertilization (IVF) in order for implantation and pregnancy to occur, the embryos must reach a stage of development known as ‘blastocyst’. Reaching the blastocyst stage is an integral part of the development of an embryo.

  • Some embryos will reach the blastocyst stage on day 5 after fertilization.
  • Other embryos develop slowly and will not reach the blastocyst stage until day 6 after fertilization.

Because of how highly complex the development to the blastocyst stage is, many embryos might never develop into blastocysts. If an embryo cannot reach the blastocyst stage, implantation and pregnancy cannot occur.

But what does it mean if the embryo makes a blastocyst on day 5 versus day 6? Is this significant? Are day 5 blastocysts better than day 6 blastocysts?

Embryo Development Review

The development of an embryo – shown in these pictures – is a time sensitive journey.

Day one after fertilization: an embryo is considered to be one-celled and is at the pronuclear stage, commonly referred to as 2PN.

Day two after fertilization,: the embryo is typically between two- to four-cells.

Day three after fertilization: the embryo has divided into six- to eight-cells. It is at this stage that the embryo begins to divide based on energy from the embryo instead of energy that was passed on in the egg.

Day four after fertilization: the embryo is at the morula stage, this is the stage just before the blastocyst stage. At this stage, cells begin to compact and form an amorphous mass, which is the very start of cellular differentiation that will occur at the blastocyst stage.

Day five and/or day six after fertilization: blastocyst formation should be occurring or have occurred. This means that there are three separate components of the embryo: The inner cell mass (ICM) which is the fetal component, the trophectoderm cells (the placental component) and the blastocoel cavity which is the fluid filled cavity that causes the blastocyst to expand and eventually hatch out of its zona pellucida (the shell).

Blastocyst Grading and Day

Let’s start by reviewing d

at how blastocysts are graded:

NUMBER: The number refers to the degree of expansion of the embryo’s cavity and goes from 2-6

  • 2 = small cavity filling a third of the embryo
  • 3 = partial expansion of the cavity filling at least 50% of the embryo
  • 4 = fully expanded cavity 100%
  • 5 = embryo has expanded so far that it has split open the shell and is starting to hatch out
  • 6 = embryo is totally hatched out of the shell

FIRST LETTER: the first letter refers to the inner cell mass (ICM) quality.

  • A = well defined clump of cells
  • B = less well defined and may be grainy in appearance
  • C = few dark cells or may be no visible mass

SECOND LETTER: the second letter refers to the trophectoderm quality.

  • A = many smooth cells of equal size forming a neat layer
  • B = many cells but layers are not quite as cohesive as A quality
  • C = very irregular cell layers with few cells

So what is more important, the grade of the blastocyst or the day of blastocyst formation?

fifth-and-sixth-day-blastocyst-grading.jpegBoth are important!

  • The grade is important because we know that blastocysts that are CC or BC or CB are very unlikely to implant and result in a pregnancy.
  • The day is important because theendometrial lining (the lining of the uterus) and the blastocyst are only in sync for a short time. If we miss that small window of implantation, even a very good quality blastocyst will not be able to implant and result in a pregnancy.

Several studies involving fresh blastocyst transfer have suggested that the rate of development to the blastocyst stage affects the pregnancy outcome of IVF treatment cycles. Studies on fresh IVF cycles have reported higher implantation and pregnancy rates with the transfer of blastocysts developing on Day 5 compared with those developing on Day 6, even though the grades were the same.

Does this mean that day 6 blastocysts are bad?

No. What it means is the blastocyst is not in sync with the uterine lining. For this reason, if there are no expanded blastocysts (expansion stage 2-4) on day 5, it is best to freeze any blastocysts that do develop on day 6 versus transferring them into the uterus on day 6. In this way, we can optimize the synchronization of the lining and the embryo in a future frozen embryo transfer. Studies have shown a low pregnancy rate (around 15% per transfer) when day-6 blastocysts are transferred. However, if they are frozen (cryopreserved) and transferred in a subsequent cycle, the pregnancy rates are once again excellent (around 50% per transfer).

Waiting can be tough when you want to get pregnant right away, but freezing any slow developing blastocysts optimizes the chance for future success.

Posted by Liza Roscetti Meyer on August 11, 2015